Transmission Installation

INSTALLATION

Transmission





Material

Installation

1. NOTE: Insert the clutch hydraulic line into the clutch slave cylinder and install the clip before tightening the transmission-to-engine bolts.

NOTE: Before installing the transmission, the input shaft must be cleaned and lubricated with grease.

To install, reverse the removal procedure.
^ Check, and as necessary, fill the transmission with transmission fluid. The total fill capacity is 3.0 liters (6.3 pints).

2. Apply Threadlock and Sealer to the fill plug threads and install the fill plug.
^ Tighten to 25 Nm (18 ft. lbs.).