Selector Lever Knob

Transmission Selector Lever Knob

Removal

1. Remove the floor console.





2. Disconnect the overdrive (O/D) switch electrical connector (selector lever assembly shown removed).





3. Remove the selector lever knob.
^ Remove the screw.
^ Pull off the knob.

Installation





1. CAUTION: When installing the selector lever knob, make sure the wiring harness is positioned forward and is centered on the shift lever shaft, or damage to the shift lever or wiring harness will occur.

Position the selector lever knob onto the lever and route the wiring harness through the transmission range indicator.





2. Slide the selector lever knob down the shaft and install the screw.





3. Connect the O/D switch electrical connector (selector lever assembly shown removed).
4. Install the floor console.