Rear Electronic (REM) Module

REMOVAL
1. Lower the convertible top.
2. Disconnect the battery ground cable.

CAUTION: Prior to removal of the module, it is necessary to upload module configuration information to the appropriate diagnostic equipment. This information needs to be downloaded into the new module once installed.







3. Remove the protective top cover screws.







4. Gently pull the two corners of the protective cover away from the top brace until the two fasteners on each side are disengaged and position the cover aside.
5. Remove the water shield







6. Disconnect the electrical connectors.







7. Remove the bolts and the REM.

INSTALLATION
1. To install, reverse the removal procedure.