Cable

REMOVAL







1. Using a trim tool, disconnect the accelerator cable from the throttle body lever. Depress the lock tab, and rotate counterclockwise to remove from the accelerator cable bracket.







2. Disconnect the accelerator cable from the retaining clip.







3. Remove the hush panel.
1 Remove the nut.
2 Remove the pin-type retainers.
3 Disconnect the lamp from the hush panel.
4 Remove the hush panel.







4. Remove the accelerator cable.
1 Remove the bolts.
2 Disconnect the accelerator cable and remove.

CAUTION: Be careful not to kink or nick the cable core wire.

INSTALLATION
1. To install, reverse the removal procedure.

CAUTION: If the accelerator cable is to be reused, inspect the locking tabs of the cable end ball stud fitting. If the locking tabs are broken, a new accelerator cable must be installed.

NOTE: The accelerator cable assembly may be supplied in two pieces. It will be necessary to snap the pieces together prior to installation.