Input Shaft and Bearing

Input Shaft and Bearing





Special Tool(s)

Disassembly and Assembly





1. Disassemble the input shaft.
1 Remove the third/fourth synchronizer blocking ring.
2 Remove the input shaft bearing race.
3 Remove the input shaft bearing.
4 Remove the input shaft washer.
5 Remove the input shaft needle bearing. Inspect all components for wear or damage. Install new components as necessary.





2. Using the special tool and a press, remove the input shaft front bearing assembly. Discard the bearing.
3. Inspect the input shaft and bearings for wear or damage. Install new components as necessary.





4. Using the special tools and a press, install the new input shaft front bearing.
5. Install the input shaft needle bearing, the washer, input shaft bearing, the bearing race and the third/fourth synchronizer blocking ring.
- Lubricate the bearing and bearing race with petroleum jelly.