Rear Door Glass Top Run

REMOVAL

All Vehicles
1. Remove the door trim panel.







2. Remove the side impact bolster.







3. Remove the door speaker (if equipped).







4. Disconnect the speaker electrical connector.







5. Detach the door latch release handle.







6. Detach the watershield.
^ Using a plastic knife (disposable cutlery), cut through the Butyl strip to enable the watershield to be peeled back.

CAUTION: Do not touch the adhesive surface as re-bonding will be impaired.

Vehicles with manual windows
7. Install the window regulator handle.

Vehicles with power windows







8. Connect the door glass operating switch electrical connector.

All Vehicles







9. Align the regulator clamp with the access hole (power window shown).







10. Detach the window glass from the regulator.
1. Push out the pin.
2. Push out the sleeve.
3. Remove the glass from the regulator clamp.

NOTE: Do not remove the glass from the door.

Vehicles with manual windows
11. Remove the window regulator handle.

Vehicles with power windows







12. Disconnect the driver door glass operating switch electrical connector.







13. Remove the door glass top run.

INSTALLATION







1. Install the door glass top run.







2. Attach the window glass to the regulator clamp.
1. Push in the sleeve.
2. Push in the pin.
3. Push the window glass firmly down to engage the pin into the regulator clamp.







3. Attach the watershield.







4. Attach the door latch release handle.







5. Connect the speaker electrical connector.







6. Install the door speaker.







7. Install the side impact bolster.
8. Install the door trim panel.