Zetec

REMOVAL

CAUTION: Do not attempt to clean the throttle body. The bore and the throttle plate have a special coating applied during manufacture which should not be removed.







1. Remove the air cleaner outlet tube.







2. Disconnect the accelerator cable.
1. Remove the retaining clip and detach the inner cable from the throttle body.
2. Rotate the outer cable.
3. Disconnect the accelerator cable.







3. Disconnect the Throttle Position (TP) sensor electrical connector.







4. Remove the throttle body.







5. Remove and discard the throttle body gasket.

INSTALLATION
1. To install, reverse the removal procedure.

CAUTION: Do not attempt to clean the throttle body. The bore and the throttle plate have a special coating applied during manufacture which should not be removed.

NOTE: Install a new gasket.