Ignition Coil: Service and Repair

"AllData Editors Note:

Customers have reported success using the following spark plug wire placement on the coil pack."






REMOVAL
1. Disconnect the battery ground cable.







2. Disconnect the ignition coil electrical connector.







3. Twist while pulling upward to disconnect the spark plug wires.

CAUTION: Spark plug wires must be connected to the correct ignition coil terminal. Mark spark plug wire locations before removing them.







4. Disconnect the accelerator cable retaining clamp from the ignition coil stud bolt.







5. Remove the bolts and the ignition coil.

INSTALLATION

1. To install, reverse the removal procedure.

NOTE:
^ Apply silicone brake caliper grease and dielectric compound to the inside of the spark plug wire coil boot.
^ Be sure to reinstall the radio ignition interference capacitor under the correct mounting bolt.