Turbine Shaft Speed (TSS) Sensor

Turbine Shaft Speed (TSS) Sensor

Removal

1. Remove the battery tray.





2. Remove the air cleaner housing.
1. Disconnect the Mass Air Flow (MAP) sensor electrical connector.
2. Disconnect the crankcase ventilation hose.
3. Disconnect the intake hose.
^ Pull out the air cleaner housing from the rubber bushes.





3. NOTE: The resonator is plugged into the bracket.

Remove the air cleaner intake pipe with the resonator.





4. Remove the TSS sensor.
^ Disconnect the TSS sensor electrical connector.
^ Remove the bolt.
^ Inspect the TSS sensor bore.





5. Inspect the O-ring seal for nicks or cuts; install a new as necessary.

Installation





1. NOTE: Apply a light coat of petroleum jelly to the O-ring seal before installation.

Install the TSS sensor.
^ Connect the TSS sensor electrical connector.
^ Apply thread sealant to the bolt.