Output Shaft Speed (OSS) Sensor
Output Shaft Speed (OSS) SensorRemoval
1. Raise and support the vehicle.
2. Place a drain pan beneath the Output Shaft Speed (OSS) sensor.
3. Remove the OSS sensor.
^ Disconnect the OSS sensor electrical connector.
^ Remove the bolt.
^ Inspect the OSS bore.
4. Inspect the O-ring seal for nicks or cuts; install a new as necessary.
Installation
NOTE: Apply a light coat of petroleum jelly to the O- ring before installation.
1. Install the OSS sensor.
^ Connect the OSS sensor electrical connector.
2. Lower vehicle.
3. Check the transmission fluid level add automatic transmission fluid or equivalent meeting MERCON V specification as necessary.
4. Start the engine and move the transaxle range selector lever through all gear positions.