Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com

Coupe






SPECIAL SERVICE TOOL(S)

REMOVAL
1. Remove the roof side trim moulding.
2. Lower the rear portion of the headliner.
3. Remove the outer lip of the moulding using a utility knife.
4. Using a soft brush or vacuum, remove any dirt or foreign material from the pinch weld.







5. Using the special tool, starting at the top center of the back window glass, cut the urethane sealant from the glass and work down the sides.

CAUTION: Care must be taken to prevent scratching the pinch weld.

NOTE: Lubricate the existing urethane sealant with water to aid the special tool while cutting.







6. Using the special tool, distance the back window glass from the body.







7. Using the special tool, cut the remaining urethane sealant and remove the back window glass.
9. Using a soft brush or vacuum, clean the pinch weld.

INSTALLATION
1. Dry-fit the back window glass by centering it side-to-side and by adjusting the setting blocks (if equipped) to get the correct position of the part top-to-bottom. Make alignment marks with tape or non-staining grease pencil on both the glass and the vehicle body.







2. Trim the remaining urethane sealant on the pinch weld using only the full-cut method. In this method, most of the existing urethane is removed leaving a level bead around the entire pinch weld.

CAUTION: Care must be taken to avoid scratching the pinch weld.

3. Using a wool applicator, apply the Urethane Metal Primer Essex U-413 meeting Ford specification WSB-M234-C to any exposed metal on the pinch weld. Allow six to ten minutes to dry.
4. If reinstalling the original back window glass, remove the urethane sealant from the back window glass.
5. If installing a new back window glass, clean the inside of the glass surface with an alcohol-free cleaner to make sure the ceramic-coated area is clean.

NOTE: If a new back window glass is to be installed, attach the new moulding to the edge of the glass starting at the top center then work down the sides and around the corners.

6. Apply Urethane Glass Prep Essex U-401 meeting Ford specification WSB-M2G314-B twice around the class surface to be prepped.

CAUTION: Wipe off the urethane glass prep immediately after each application because it flash dries. Apply deliberate strokes, making sure not to overlap the applied area.

7. Apply Urethane Glass Primer Essex U-402 meeting Ford specification WSB-M5B280-C to the same area that was in the previous step. Allow five minutes to dry.







8. Cut the applicator tip to specification.







9. Apply a bead of Urethane Sealant Essex 400-HV or Essex U-216 meeting Ford specification WSB-M2G316-B to the pinch weld.

CAUTION: If the vehicle is to be driven within 24 hours of urethane sealant application, Urethane Sealant Essex U-216 meeting Ford specification WSB-M2G316-B must be used due to its one hour cure time.

10. Using the alignment marks install the back window glass.

CAUTION: Open a window to prevent the back window glass from being pushed out by air pressure when the door is closed.

11. After the glass is set, check for water leaks and add urethane sealant where needed.
12. Install the headliner.
13. Install the roof side trim moulding.