Headlamp Lens Condensation Concerns

Headlamp Lens Condensation Concerns
Procedure
If there is a concern over the formation of condensation inside the plastic headlamp lens or if the plastic headlamp lens is split.

NOTE: It is normal for a small amount of condensation to form on the inside of the plastic headlamp lens, it will disappear when the headlamp is switched on. If the headlamp does NOT dry out after having been switched on for 15 minutes, check the build date of the headlamp. If the build date is between 01.08.98 and 30.09.98, install a new headlamp cover flap. The build date can be obtained from the eight digit number on the white sticker on the top of the headlamp. The last four digits give the day and month.

Because of stresses caused by its mounting, a split may appear in the plastic headlamp, and moisture will then enter. If there is a concern, both headlamps must be removed. Defective headlamps must be renewed and reworking may be necessary. When the headlamp is installed, the number of mounting points must be reduced. For additional information, refer to Headlamp, Remove and Install.