Evaporative System Service Port: Service and Repair

REMOVAL







1. Disconnect the pin-type retainer.
2. Raise the vehicle.
3. Remove the RH front wheel.







4. Remove the RH front splash shield.
1 Remove the three screws.
2 Remove the five pin-type retainers.







5. Remove the evaporative emission test port by disconnecting at the EVAP canister purge outlet tube junction.

INSTALLATION
1. To install, reverse the removal procedure.
2. Leak test the system. EVAP System Leak Test
3. Carry out the Evaporative Emission Running Loss Monitor Repair Verification Drive Cycle.