Synchronizers

Disassembly

Note: The following procedure applies to all the synchronizer assemblies.

1. Scribe an alignment mark on the sleeve and the hub.





2. Remove the synchronizer strut springs and the synchronizer struts.
3. Remove the sleeve.

Assembly

1. Note: When assembling a synchronizer sleeve and hub, match the alignment marks made during disassembly. The sleeve and hub have an extremely close fit and must be held square during assembly to prevent jamming. Do not force the sleeve onto the hub.

Assemble the synchronizer hub struts and the strut springs. The strut springs engage the same insert but rotate in opposite directions.
2. Install the sliding sleeve.