Countershaft

Special Tools:

DISASSEMBLY

NOTE: Remove the front countershaft bearing race only if it is worn or damaged. If the bearing race is removed, Thread Lock and Sealer EOAZ-19554-AA or equivalent meeting Ford specification WSK-M2G315-A5 (Type 11) must be used during installation.

CAUTION: Failure to properly support the case will result in permanent distortion of case during bearing race removal.





Using a press and Remover Tube T77J-7025-B, Mainshaft Front Bearing Replacers T82T-7003-DH and T77J-7025-M and Countershaft Front Bearing Replacer T77J-7025-L (assembled to case), remove bearing race with O-ring from case.

ASSEMBLY





1. Install shift shaft lever seal onto bearing race. Coat bearing race outside diameter with Thread Lock and Sealer EOAZ-19554-AA or equivalent meeting Ford specification WSK-M2G315-A5 (Type 11) and position bearing race to case.





2. Using Pinion Bearing Cone Replacer T57L-4621-B and Remover/Replacer Tube T75L-7025-B, support transmission case on press. Press bearing race until flush with case.