Valve Body

DISASSEMBLY
1. Remove retaining bolt and shift solenoid bracket.





2. Remove shift solenoid assembly and Torque Converter Clutch solenoid (TCC solenoid) by pulling straight up.





3. Turn main control valve body over and remove 10 bolts retaining reinforcement and separator plates.





4. Remove separator plate and gaskets. Discard gaskets.





5. Note location and remove check balls. Remove solenoid screen.
6. Remove converter drain back valve.





7. Remove eleven valve body cover plate bolts and two guide pin bolts.
8. Remove main control cover.

ASSEMBLY





1. Install main control cover.





2. Install two guide pin bolts and eleven valve body cover retaining bolts. Tighten guide pin bolts to 9 - 11 Nm (80 - 97 inch lbs.) and valve body cover retaining bolts to 9 - 11 Nm (80 - 97 inch lbs.) in sequence shown.
3. Install coasting booster valve shuttle balls, converter drain back valve and solenoid screen.
4. Install separator plate and new gaskets.





5. Install reinforcement plates. Tighten retaining bolts to 9 - 11 Nm (80 - 97 inch lbs.) in sequence shown.





6. Inspect wirings on solenoids for damage. Install shift solenoid assembly and torque converter clutch solenoid.





7. Install bracket and retaining bolt. Tighten to 9 - 11 Nm (80 - 97 inch lbs.).