Traction-Lok Differentials

WARNING: NEVER RUN ENGINE WITH ONE WHEEL OFF THE GROUND.

A Traction-Lok differential can be checked for proper operation without removing it from the rear axle housing.
1. Raise one rear wheel and remove the wheel cover. Install adapter from Traction Lok Torque Tool 205-013 (T59L-4204-A) on the lug bolts.





2. Using a torque wrench with at least 271 Nm (200 ft. lbs.) capacity, rotate the axle shaft. Be sure the transmission is in NEUTRAL, one rear wheel is on the floor and the other rear wheel is raised off the floor. The breakaway torque required to start rotation should be at least 27 Nm (20 ft. lbs.). The initial breakaway torque may be higher than the continuous turning torque. The axle shaft should turn with even pressure throughout the check without slipping or binding. If the torque reading is less than specified, check the differential case for internal damage.