Cruise Control Switch: Service and Repair

REMOVAL
1. Disconnect positive battery cable and wait one minute. This is the time required for the air bag diagnostic monitor power supply to deplete its stored energy.

2. Remove the driver side air bag. Service and Repair

3. Remove five screws and upper and lower steering column shrouds from steering column.

4. Rotate steering wheel to gain access to driver side air bag module retaining bolts on rear of steering wheel.

5. Remove two driver side air bag module retaining bolts from rear of steering wheel.

6. Disconnect the speed control actuator switch electrical connector.

7. Remove the four switch clips (two each side) from the speed control actuator switch and remove speed control actuator switch.

8. Remove the steering wheel.

9. Remove the steering wheel cover.

10. Disconnect the speed control actuator switch electrical connectors.

11. Push the speed control switches out through the front of the steering wheel.

INSTALLATION

1. Install speed control actuator switches.

2. CAUTION: Make sure wires are positioned so that no interference is encountered when installing air bag module.

Connect the speed control actuator switch electrical connector.

3. Install the steering wheel cover.

4. Install the steering wheel

5. Install driver side air bag module on steering wheel. Service and Repair

Install two bolts. Tighten to 10-19 N.m (89-124 Lb-In).