Transmission Position Sensor/Switch: Adjustments

1. Disconnect the battery ground cable.
2. Remove the engine air cleaner.
3. Place the gearshift lever in the NEUTRAL position.

CAUTION: Apply the parking brake and block the wheels prior to removing the shift cable and bracket.





4. Remove the transmission shift cable from the manual control shift outer lever. Use a screwdriver or suitable tool to pry the shift cable and bracket from the manual control shift outer lever.
5. Disconnect the Transmission Range (TR) sensor electrical connector.
6. Loosen the two TR sensor bolts.





7. Rotate the TR switch until the neutral mark lines up with the TR switch shaft as shown.









8. Use a Rotunda 73 Digital Multimeter 105-R0051 (or equivalent) and ensure that there is continuity between the TR switch terminals.
9. Tighten the TR sensor bolts to 8-10 Nm (71-88 lb in).
10. Connect the TR sensor electrical connector.
11. Install the transmission shift cable on the manual control shift outer lever.
12. Install the engine air cleaner.
13. Connect the battery ground cable.