Rear of Vehicle (Rear)

REMOVAL
1. Raise and support the vehicle.
2. Remove the spindle through bolt nut and the spindle through bolt.
3. Remove the rear stabilizer bar link.

NOTE: Before removing the adjusting cam bolt, make a mark on the cam plate and the rear floor cross member for reference during installation.





4. Remove the adjusting cam nut, the adjusting cam plate, and the adjusting cam bolt.
5. Remove the rear suspension arm and bushing (rear).

INSTALLATION
To install, reverse the removal procedure noting the following:
^ Tighten the spindle through bolt nut to 86-117 Nm (64-86 ft. lbs.).
^ Tighten the adjusting cam nut to 78-117 Nm (58-86 ft. lbs.).
^ Check the vehicle alignment.