Rear

REMOVAL
1. Disconnect the battery ground cable.
2. Remove the rear wheel and tire assembly.
3. Remove the rear brake anti-lock sensor bolt from the rear wheel spindle. Remove the rear brake anti-lock sensor.
4. Remove the routing bracket from the spring and shock.
5. Remove the routing bracket from the inner fender well.
6. Remove luggage compartment interior panels as necessary to gain access to the wiring harness.
7. Disconnect the rear brake anti-lock sensor electrical connector.
8. Remove the rear brake anti-lock sensor.

INSTALLATION

(Part 1 Of 2):

(Part 2 Of 2):

1. Route the rear brake anti-lock sensor wiring harness in the vehicle. Connect the rear brake anti-lock sensor electrical connector.

NOTE: The left and right rear brake anti-lock sensors are-not interchangeable. "L" or "R" is indicated on the bracket.

Make sure that the wiring harness will clear all suspension components.

2. Install the routing bracket onto the inner fender well. Tighten the rear routing bracket bolt to 9-13 Nm (81-113 inch lbs.).
3. Install the routing bracket onto the spring and shock. Tighten the rear routing bracket bolt to 18-25 Nm (13-19 ft. lbs.).
4. Install the rear brake anti-lock sensor into the rear wheel spindle. Tighten the rear brake anti-lock sensor bolt to 16-23 Nm (12-17 ft. lbs.).
5. Ensure that the clearance between the rear brake anti-lock sensor and rear brake anti-lock sensor indicator is 0.3-1.1 mm (0.012-0.043 inch).
6. Install any luggage compartment interior panels that were removed.
7. Install the rear wheel and tire assembly. Tighten the lug nut to 88-118 Nm (65-87 ft. lbs.).