Accelerator Cable

Accelerator Cable Bracket:

REMOVAL and INSTALLATION
1. Remove the air cleaner housing.
2. Using a suitable tool, push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm.
3. Remove the accelerator cable retainer from the accelerator cable. The accelerator cable retainer is located inside the vehicle where the housing passes through the dash panel into the passenger compartment.
4. Disconnect the accelerator cable at the throttle body throttle lever by removing the core wire end from the throttle body cam slot.
5. Remove the screw retaining accelerator cable to accelerator cable bracket.
6. Remove screws retaining the accelerator cable to the dash panel and remove accelerator cable.
7. To install, reverse removal procedure and make sure accelerator cable retainer is pushed 6.35 mm (0.25 inch) onto accelerator cable. Tighten cable to bracket bolt to 5-7 Nm (45-61 lb in).