Cruise Control Servo: Service and Repair

REMOVAL

1. Disconnect speed control actuator from throttle body.
2. Raise vehicle on hoist.
3. Remove LH front wheel and tire assembly.
4. Remove front fender splash shield.
5. Disconnect speed control servo electrical connector.
6. Remove two retaining screws from speed control servo bracket to fender rail.
7. Remove three screws retaining speed control servo to speed control servo bracket.






8. Remove speed control cable cap from speed control servo by pressing cap locking arm and rotating speed control cable cap counterclockwise.






9. Remove speed control cable slug from speed control servo pulley. Gently push actuator cable slug past retaining spring with a small screwdriver.

INSTALLATION

1. Install speed control servo to speed control servo bracket. Tighten screws to 6-7 N.m 53-62 (lb-in).






2. Make sure that the rubber seal is snug against speed control actuator cap.
3. Install speed control actuator cable slug into speed control pulley slot. Make sure that the slug is fully installed past the retaining spring.

NOTE: Incorrect wrapping of speed control actuator cable core around speed control servo pulley may cause a high idle condition. Make sure that the throttle lever is at the idle position after speed control cable installation and adjustment.

4. Pull on throttle attachment end of speed control actuator cable and draw the speed control actuator cap onto the speed control servo pulley.






5. Install speed control actuator cap by inserting locking tabs into speed control servo slots. Rotate cap clockwise until cap locking arm engages slot on speed control servo.

NOTE: Proper assembly of speed control servo can be verified by a white band on the speed control actuator cable being visible.






6. Install speed control cable and speed control servo. Tighten screws to 8-12 N.m (71-106 lb-in).
7. Connect harness connector to speed control servo
8. Install front fender splash shield.
9. Install LH front wheel and tire assembly.
10. Lower vehicle.
11. Attach speed control actuator to throttle body lever.