Front

CALIPERS
^ Are pin slider-type disc brake calipers.
^ Have a single steel caliper piston with a piston seal and a press-in type dust boot.
^ Are attached to a front disc brake caliper anchor plate.
^ The front disc brake caliper anchor plate is attached to the front wheel spindle with two 12 mm attaching bolts.
^ Slide on lubricated disc brake caliper locating pins that are sealed from the elements by rubber boots.
^ The disc brake caliper locating pins are attached to the caliper housing by two pinch bolts.

SPLASH SHIELDS
^ Vehicles are equipped with galvanized steel front disc brake rotor shields that are attached to the front wheel spindle with three pop-rivets per side that are not interchangeable side-to-side.

PADS/SHOES
^ Are fully interchangeable (no LH, RH, no inner/outer).
^ Slide into the caliper anchor bracket assembly.
^ use a single purpose clip which holds the brake shoes and linings against the anchor bracket to prevent brake shoe rattles.

ROTORS - are;
^ 330 mm (12.9 inch).
^ a ventilated full-cast design.
^ assembled so that a mounting hole identified with yellow paint is matched with the yellow painted lug bolt.
^ serviced with the front disc brake caliper/front disc brake caliper anchor plate assembly removed.