Headlamp Switch

REMOVAL
1. Disconnect battery ground cable.
2. Remove LH instrument panel finish panel.

Headlamp switch knob removal:

3. Grasp the headlamp switch knob and shaft and slide a small pin into the hole in the bottom of the headlamp switch knob to release the locking tab, pull the headlamp switch knob straight away from the headlamp switch.






4. Remove three screws retaining the headlamp switch retainer to the LH instrument panel finish panel.
5. Press locking tabs on the headlamp switch retainer and separate the retainer.
6. Press locking tabs on the headlamp switch and remove the headlamp switch from the headlamp switch retainer.

INSTALLATION
1. To install, reverse Removal procedure.
2. Tighten screws to 3 Nm (25-26 in lb).