C4 Check Solenoid Wires to Anti-Lock Brake Control Module

- Key OFF.

- Locate and disconnect the anti-lock brake control module connector C1.

- Disconnect the hydraulic anti-lock actuator assembly connector C1.

- Measure the resistance of the following wires between the anti-lock brake control module connector C1 and the hydraulic anti-lock actuator assembly connector C1.

Control Module Actuator Assembly
Connector Wire Connector Wire

Left Front "Y/GN" (C1-6) "Y/GN" (C1-3)

Right Front "BL/O" (C1-2) "BL/O" (C1-7)

Left Rear "BR" (C1-7) "BR" (C1-4)

Right Rear "BK/Y" (C1-1) "BK/Y" (C1-8)

- Are the resistances less than 5 ohms?

YES -- Go to G1. G1 Check System Integrity

NO -- Service the wire(s) in question.