Climate Control Assembly

REMOVAL
1. Disconnect battery ground cable.

CAUTION: Do not use excessive force when installing removing tool. This will damage retaining clips, making radio chassis or digital audio compact disc player removal difficult.

2. Install Radio Removing Tool T87P-19061-A into radio face plate or digital audio compact disc player face plate. Push tool in approximately 25.4 mm (1 inch) to release retaining clips.





3. Apply a slight spreading force on tool and pull radio chassis or digital audio compact disc player from instrument panel.





4. Disconnect the connectors and remove the radio chassis and/or digital audio compact disc player.
5. Snap finish panel away from instrument panel.
6. Disconnect light switch rheostat resistor wiring connector.





7. Remove two screws and heater control from the instrument panel.
8. Disconnect wire connectors from the heater control.





9. Disconnect vacuum hose harness from heater control.


INSTALLATION
1. Connect wire connector(s) and vacuum hose harness to heater control.
2. Position heater control in instrument panel and install retaining screws.
3. Connect dash dimmer switch wiring connector.
4. Connect wiring connectors and antenna cable to radio chassis.
5. Slide radio chassis into instrument panel, making sure that radio chassis or rear radio chassis support of the digital audio compact disc player is engaged on the upper support rail.
6. Push radio chassis or digital audio compact disc player inward until retaining clips are fully engaged.
7. Connect battery ground cable.
8. Test radio chassis and digital audio compact disc player for operation.