Impact Sensor: Description and Operation

WARNING: Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag system has been involved in a crash where the fenders or grille area have been damaged, inspect the sensor mounting brackets for deformation. If damaged, the sensor should be replaced whether or not the air bag is deployed. In addition, ensure that the body structure in the area of the sensor mounting is restored to its original condition.

Sensor Locations:

The three air bag sensors are located at the front of the vehicle along the body chassis. Two front air bag sensor and brackets are located beneath the front fenders on the right and left front bumper cover supports. The center air bag sensor and bracket is located on the radiator support.

The air bag sensors each consist of:
- a sensing mass
- a bias magnet
- a cylindrical tube
- two electrical contacts

Sensor:

ITEM DESCRIPTION
1. Air Bag Sensor
2. Electrical Contacts
3. Cylinder
4. Bias Magnet
5. Sensing Mass






ITEM DESCRIPTION
1. Bias Magnet
2. Sensing Mass
3. Resultant Force
4. Bias Force
5. Inertial Force
6. Electrical Contacts

During normal operation, the bias magnet holds the sensing mass in place against the magnet. The two electrical contacts remain open during normal operation. Upon impact, the sensing mass pulls away from the bias magnet and rolls down the cylinder toward the electrical contacts. When the sensing mass hits the electrical contacts, it completes the air bag deployment circuit.

When the circuit is completed, it grounds the igniter in the air bag modules and the air bags are deployed.

NOTE: At least one forward or center air bag sensor and the safing sensor must be activated simultaneously to inflate the air bags.

Unless the air bag sensor is damaged during impact, the sensing mass returns to its original position after making contact.