PCM - MIL ON/DTCs P0300 Through P0304, or P0110 Set
Article No.96-18-2
08/26/96
^ MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATED - DIAGNOSTIC TROUBLE CODES (DTCS) P0300, P0301, P0302, P0303, P0304, OR P0110
^ LAMP - MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATED - DIAGNOSTIC TROUBLE CODES (DTCS) P0300, P0301, P0302, P0303, P0304, OR P0110
FORD:
1996 ASPIRE
CALIBRATION:
6FB3EMON, 6FB3EM0A, 6FB3EA0N, 6FB3EA0A, 61B3EM0N, 61B3EM0A, 61B3EA0N, 61B3EA0A
WARNING:
THIS MODIFICATION IS AUTHORIZED ONLY FOR THE LISTED ENGINE. PERFORMING THIS MODIFICATION ON OTHER ENGINE CALIBRATIONS IS UNAUTHORIZED AND COULD CREATE LIABILITY UNDER APPLICABLE FEDERAL OR LOCAL LAWS.
ISSUE:
The Malfunction Indicator Lamp (MIL) may illuminate with no driveability concern present on some vehicles. Diagnostic Trouble Codes (DTCs) P0300, P0301, P0302, P0303, P0304, and/or P0110 are present. This may be caused by the Powertrain Control Module (PCM) calibration.
ACTION:
Replace the PCM with a revised PCM. Refer to the following Service Procedure for details.
SERVICE PROCEDURE
Verify the DTC It should be P0300, P0301, P0302, PO303, P0304, and/or P0110 and repair per the following Steps.
DTC: P0300, P0301, P0302, P0303, OR P0304
1. Replace the PCM with the revised PCM listed in the PCM Application Chart and retest. Refer to the 1996 Aspire Service Manual, Page 03-14-5, for PCM replacement.
2. If the DTC still exists, refer to the 1996 Powertrain Control/Emissions Diagnosis (PC/ED) Service Manual, Section 6B-189, for diagnostic procedures and repair as needed.
DTC: P0110
1. Inspect the Intake Air Temperature (IAT) sensor following the procedure outlined in the PC/ED, Section 6B-16.
2. If the IAT is at fault, replace the IAT following the Service Manual, Page 03-14-6, and retest.
3. If the IAT tests good, replace the PCM with the revised PCM listed in the PCM Application Chart. Refer to the 1996 Aspire Service Manual, Page 03-14-5, for replacement procedures and retest.
Obtain an Authorized Modifications Decal and list the date, dealer number, and summary of modifications performed. Select a prominent place adjacent to the Vehicle Emission Control Information Decal suitable for installing the Authorized Modifications Decal. Clean the area, install the decal, and cover it with a clear plastic decal shield.
PART NUMBER PART NAME
F6BZ-12A650-J Powertrain Control Module (PCM)
F6BZ-12A650-K Powertrain Control Module (PCM)
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage And Emissions Warranty Coverage
OPERATION DESCRIPTION TIME
961802A Replace Powertrain Control 0.3 Hr.
Module (PCM)
DEALER CODING
CONDITION
BASIC PART NO. CODE
12A650 42
OASIS CODES: 206000, 698298