Ignition Coil Pack

REMOVAL
1. Disconnect battery ground cable.
2. Disconnect engine control sensor wiring connector from ignition coil and radio ignition interference capacitor.

Ignition Coil And Mounting Bracket:

3. Remove ignition wires by squeezing locking tabs to release ignition coil boot retainers.
4. Remove ignition coil retaining screws and remove ignition coil and radio ignition interference capacitor.

INSTALLATION
1. Install ignition coil and radio ignition interference capacitor and retaining screws. Tighten retaining screws to 4.5-7.0 Nm (40-61 in lb).

Ignition Wiring Routing:

2. Connect ignition wires. Refer to Ignition Wiring Routing illustration. Connect engine control sensor wiring connector to ignition coil and radio ignition interference capacitor.
3. Connect battery ground cable.