Spark Plug: Service and Repair
REMOVAL1. Remove ignition wires.
2. Loosen spark plugs a 1/4 turn and remove any dirt or foreign material from spark plug areas of cylinder head with compressed air.
3. Remove spark plugs.
NOTE: Three different styles of Platinum enhanced spark plugs are produced for this engine. Each plug has a different part number, and use. AWSF-44P spark plugs have a platinum enhanced center electrode and are used in cylinders 4, 5, and 6. AWSF-44PG spark plugs have a platinum enhanced ground (side) electrode, and are used in cylinders 1, 2, and 3. If any spark plug is removed and re-installed, it MUST be installed in the same cylinder from which it was removed. If any spark plug is replaced, use only spark plugs with part number AWSF-44PP (as listed on the VECI label). This replacement spark plug has double platinum enhancement on both the center and ground electrode and may be used in all six cylinders.
NOTE: Refer to the Spark Plug Inspection Chart to determine the condition of the spark plugs.
4. Check and adjust spark plug gap.
INSTALLATION
1. To install, reverse Removal procedure.
2. Tighten spark plugs to 9-20 Nm (7-15 ft lb).