Throttle Body: Service and Repair

Throttle Body:

REMOVAL

1. Remove air cleaner outlet tube.

2. Disconnect throttle position sensor from the fuel charging wiring and accelerator cable and extension spring at the throttle lever.

3. Remove the four throttle body bolts.

4. Carefully separate the throttle body from the intake manifold adapter.

5. Remove and discard the gasket.

6. Clean the gasket sealing surfaces.

INSTALLATION

1. Clean gasket mating surfaces.

NOTE: If scraping is necessary, be careful not to damage gasket surfaces or allow material to drop into manifold.

1. Install throttle body, new gasket and the four bolts to the adapter. Tighten the bolts to 8.0-12.0 Nm (71-106 lb in).

2. Connect the throttle position sensor and the throttle linkage. Install air cleaner outlet tube.