Test Notes

NORMAL OPERATION
The air bag indicator is designed to light for six (+/-two) seconds when the ignition switch is turned to RUN. This initial six seconds of air bag indicator illumination is considered normal operation and is called "prove-out" of the air bag indicator. If there is an open in the air bag indicator circuit at Pin 11, a no air bag indicator fault will occur and this prove-out will not be seen.

If the computer in the air bag diagnostic monitor detects an open in the air bag indicator circuit and if another system fault exists, then the air bag diagnostic monitor will turn on its internal tone generator (beeper). The beep pattern is five sets of five beeps. The pattern is repeated every 30 minutes while the ignition switch is in RUN. The five beeps do not indicate a code 5 or any other code. The indicator circuitry must be serviced before the diagnostic trouble code can be read.

The air bag diagnostic monitor requires power at Pin 6 to energize the air bag indicator circuit properly. Loss of ignition voltage at Pin 6 due to open circuit or short to ground will result in a continuous air bag indicator due to the ignition voltage applied to Pin 19.

If the air bag diagnostic monitor is disconnected or not firmly plugged in, a shorting bar in the black air bag diagnostic monitor harness connector shorts Pins 10 and 11, turning the lamp on continuously.

POSSIBLE CAUSES

An inoperative air bag indicator circuit can be caused by:

- A burned out bulb or open wiring in the air bag indicator circuit.