Attachment III - Technical Instructions
Probe Fog Lamp Switch InstallationTechnical Instructions
ATTENTION:
After Fog Lamp Switch installation and functional test, complete remainder of installation by reversing the removal procedures.
I Centre Console Armrest Removal
1. Open the armrest and remove the two screws that attach the armrest compartment to the base of the armrest. Refer Figure 1.
2. Remove the armrest compartment
3. Remove the two screws that attach the base of the armrest to the ashtray housing. Refer Figure 2.
4. Remove the armrest.
II Floor Console Removal
1. If equipped with a manual transaxle, unscrew the shifter knob.
2. If equipped with a automatic transaxle, remove the emergency override key switch cover (as shown in Figure 3).
3. Engage the parking brake.
4. Gently pull up on the upper half of the floor console to separate it from the lower half. Position it away from the instrument panel to gain access to the console bezel screws.
III Control Console Bezel Removal
1. Remove the two control console bezel screws. Refer Figure 4.
2. Gently pull the control console bezel away from the instrument panel to gain access to the Fog Lamp Switch Blank.
NOTE:
Observe the (5) clip locations and gently pull only at these areas being careful not to dislodge the clips. Refer to Figure 4.
3. Disconnect the fog lamp switch blank electrical connector (ORANGE).
4. Squeeze the lock tabs of the fog lamp switch blank and remove the blank form the control console bezel. Mutilate and scrap the removed fog lamp switch blank.
IV Fog Lamp Switch Installation
1. Move the Headlamp Retractor button to the extreme right position; and reconnect the GREEN electric connector. Install functional fog lamp switch (F32Z-15A214-C) in the second position from right on the control panel. Refer Figure 5.
2. Push the fog lamp switch electrical connector (ORANGE) onto the fog lamp switch. Ensure connector is secured by the lock tabs on the switch.
3. Check to ensure that the Daytime Running Light (DRL) system and Fog Lamps function properly - both illuminate through the same lamps.
^ Daytime Running Light System
In Canada, certain regulations require vehicles to be driven with lights illuminated during daytime operation. It is for that reason that the daytime running lights (fog lamps) are automatically illuminated when the ignition switch is turned to the ON position. The daytime running lights are switched OFF under the following conditions:
when the headlamps are switched ON
when the parking brake is applied
when the flash-to-pass system is used
^ Fog Lamps
The Fog Lamps only operate when the headlamps are on "Low Beam". To activate fog lamps, push the button on the control panel below the climate controls. An indicator light on the button will illuminate. Push the button again to turn the fog lamps off.
4. Complete the installation by reversing the removal procedures.