Rear Package Tray - Revised Service Procedure

Article No.
92-18-3

08/26/92

PACKAGE TRAY - SERVICE PROCEDURE - UPDATE

FORD:
1993 PROBE

ISSUE:
Service Manual removal and installation procedures have been updated for the package tray assembly. The new procedure now identifies the forward package tray tie down cord.

ACTION:
When removing or installing the package tray assembly, refer to the following procedure for service details.

REMOVAL AND INSTALLATION PROCEDURE

1. Open the liftgate





2. Disconnect the two rear tray liftcords from the liftgate trim. Refer to Figure 1.

3. Disconnect the two front package tray tie down cords from the lower trunk side trim. Refer to Figure 1.

4. Remove the package tray by raising and pulling toward the rear of the vehicle.

5. To install, reverse the removal procedure.

NOTE:
ENSURE ALL FOUR LIFTCORDS ARE SECURED DURING INSTALLATION.

WARRANTY STATUS:
INFORMATION ONLY

OASIS CODES:
190000