Transmission Speed Sensor: Service and Repair
Removal1. Disconnect the negative battery cable.
2. Remove the air cleaner assembly.
3. Remove the two upper transaxle mount nuts and bolt.
4. Remove the upper transaxle mount through bolt.
NOTE: It is not necessary to disconnect the fuel lines from the fuel filter.
5. Remove the fuel filter bracket bolts from the LH transaxle mount. Position the fuel filter and bracket aside.
6. Remove the upper transaxle mount.
7. Disconnect the pulse signal generator connector.
Pulse Signal Generator.:
8. Remove the pulse signal generator mounting bolt.
9. Remove the pulse signal generator.
Installation
1. Apply ATF to the 0-ring.
2. Install the pulse signal generator.
3. Tighten the pulse signal generator mounting bolt to 8-10 N-m (71-88 b-in).
4. Connect the pulse signal generator connector.
5. Install the upper transaxle mount.
6. Install the two upper transaxle mount nuts and bolt.
7. Tighten the transaxle mount nuts and bolt to 67-93 N-m (50-68 lb-ft).
8. Install the upper transaxle mount through bolt.
9. Tighten the upper transaxle mount through bolt to 86-116 N-m (63-86 lb-ft).
10. Install the fuel filter and bracket on the upper transaxle mount.
11. Tighten the fuel filter bracket bolts to 8-10 N-m (71-88 lb-in).
12. Install the air cleaner assembly.
13. Connect the negative battery cable.