Automatic Transmission

Data Link Connector:

1. Warm engine to operating temperature.
2. Turn all electrical loads "OFF."
3. Connect Rotunda Digital Tachometer (059-00007), or equivalent.
4. Connect timing light.
5. Connect Data Link Connector terminals STI (TEN) and GND with jumper wire.
6. Verify correct idle speed. Adjust if needed:

IDLE SPEED: 700 ± 50 rpm

Timing Marks:

7. Check timing:

TIMING: 12° ± 1° BTDC

8. If not correct, loosen hold-down bolts and turn distributor to adjust.
9. Tighten hold-down bolts:

TORQUE: 14 - 18 ft lb (19 - 25 Nm)

10. Remove test equipment and jumper wire.