Transistorized High Energy System

REMOVAL

Distributor R&R:

1. Disconnect battery negative cable.
2. Unplug distributor and coil electrical connectors.
3. Remove attaching screws and distributor cap; position cap and wires out of the way.
4. Rotate engine to #1 cylinder TDC firing.
5. Remove distributor hold-down bolts; lift distributor from engine.

INSTALLATION

Distributor Alignment Marks:

1. Match alignment marks on distributor shaft and housing.
2. Apply oil to O-ring.
3. Install distributor, ensuring that distributor and camshaft gears engage.
4. Ensure that rotor points to #1 wire tower. If not, pull distributor out and rotate shaft one tooth. Repeat this step until rotor is aligned with #1 wire tower.
5. Install distributor cap and plug in connectors for distributor and coil.
6. Install and temporarily tighten hold-down bolts.
7. Connect negative battery cable.
8. Adjust timing.
9. Tighten hold-down bolts:

TORQUE: 14 - 18 ft lb (19 - 25 Nm)