IGNA12 - Check PIP Sensor

^ Key OFF.

^ Disconnect diagnostic harness PIP sensor tee from PIP sensor only; leave PIP sensor tee connected to vehicle harness.

^ DVOM on DC volt scale.

^ Key ON.

^ Measure the voltage between Pin 34 (PIP) and Pin 7 (BAT).

^ Is the voltage greater than 9 volts DC?


YES -- Check PIP sensor wiring, if OK replace distributor. Remove all test equipment. Reconnect all components. Clear continuous memory. Rerun quick test.

NO -- GO to IGNA13. IGNA13 - Check PIP Signal With TFI Disconnected