2 Door and 3 Door

The Window Control Switch in each door sends current through the Window Motor in one direction for UP and the opposite direction for DN.

The current causes the Window Motor to turn in a clockwise or counterclockwise direction to raise or lower the window.

In the OFF position, both motor wires are grounded through separate switch contacts.

When the DN switch is pushed, power flows to the DN Motor lead. The UP lead acts as ground.

When the UP switch is pushed, power flows to the UP Motor lead. The DN lead acts as ground.

Each motor assembly also has a circuit breaker to cut off power if a switch is held too long in the UP or DN position.

The 2-door and 3-door Power Window System are protected by Circuit Breaker 14, which is hot with the Ignition Switch in ACC or RUN position.