Distributor: Service and Repair

REMOVAL

Distributor Unit:

NOTE: Cap, rotor, inner and outer covers, and O-ring can be replace individually. Distributor should be replace as a unit. Do not attempt to disassemble and service distributor assembly.

1. Disconnect negative battery cable.
2. Disconnect coil wire from distributor.
3. Remove distributor cap attaching screws.
4. Pull distributor cap off and position it aside.

Electrical Connector:

5. Disconnect distributor electrical connector.
6. If distributor unit is not being replaced, scribe a reference mark across distributor base flange and cylinder head. Mark will permit installation without changing timing. Note rotor position for installation reference.

Distributor Unit:

7. Remove bolts and distributor unit.

Distributor Unit:

8. If replacement is needed, remove O-ring from distributor unit.

INSTALLATION

Distributor Unit:

1. If needed, install new O-ring.

NOTE: When installing distributor, make sure offset drive tangs engage with camshaft slots.

2. Position distributor and install mounting bolts.

NOTE: If distributor was not replaced, align reference marks made during removal and tighten mounting bolts. Rotor should be in same position as when removed.

Torque To: 19 - 25 Nm (14 - 19 ft lb)

3. Install distributor electrical connector.
4. Install distributor cap and screws.
5. Install coil wire.
6. Install the negative battery cable.

NOTE: If new distributor is installed, check and adjust ignition timing.