Convertible

REMOVAL AND INSTALLATION
1. Remove rear seat cushion.

NOTE: Rear seat must be unlatched at front edge and pulled forward to remove bolts attaching buckle ends.
2. Remove two screw attachments of the retractor webbing guide at the rear seat back.
3. Remove luggage compartment liner.
4. Remove retractor webbing and anchor bolt through the top sling from the luggage compartment.
5. Remove safety belt anchor to floorpan bolt.
6. Remove safety belt anchor end through the seat back boot.
7. Position replacement components as shown. Reverse Steps 1 through 6. Tighten attachments to 30-43 Nm (22-32 lb-ft).