Throttle Valve Linkage
ADJUST1. Locate the Self-Test and Self-Test Input (STI) connectors in engine compartment. The two connectors are located next to one another near the passenger side of dash panel or righthand fender apron.
2. Connect a jumper wire between the STI connector and the signal return ground on the Self-Test connector.
3. Turn ignition key to the RUN position. The ISC plunger will retract fully after approximately 10 seconds.
NOTE: Do Not Start Engine.
4. Loosen the bolt on the sliding trunnion block on the TV control rod assembly a minimum of one turn. Remove any corrosion from the control rod and free up trunnion block so that it slides freely on the control rod.
5. With engine idling in PARK, rotate transaxle TV control lever up using one finger and a light force (approximately one pound) to ensure that the TV control lever is against its internal idle stop. Without relaxing the force on the TV Control Lever, torque bolt on trunnion block to 4-7 ft lb.
6. Turn key to OFF and remove jumper wire.