Headlamp Dimmer Switch: Service and Repair

1. On models equipped with airbag, disarm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2. On all models, disconnect battery ground cable and isolate cable end with electrical tape.
3. Remove steering column shroud retaining screws, then the upper and lower shrouds.
4. Remove electrical connectors.
5. Remove two self-tapping screws, attaching multi-function switch to the steering column.
6. Remove switch from column.
7. Reverse procedure to install, noting the following:
a. Torque self-tapping screws to 17-25 ft. lbs.
b. Torque shroud screws to 6-10 inch lbs.
c. Check switch for proper operation.
d. Reactivate airbag system.