RH Front Door Window Switch

Removal and Installation
High Series (Low Series shown below)






1. Remove screw from the front end of the bezel and lift bezel and switch away from the armrest.
2. Remove bezel and nut from the mirror remote control, if so equipped.
3. Remove two retaining nuts from the bezel studs and separate the switch from the bezel.
4. Pull the switch from the switch connector.
5. To install, position the switch to the connector and press together firmly.
6. Position the switch to the bezel and install the two retaining nuts.
7. Install the bezel and nut on the outside mirror remote control, if so equipped.
8. Position the switch and bezel to the armrest and install the retaining screw.

Removal and Installation
Low Series Single Switch

Single Switch - Door Panel Mounted:

1. Remove switch housing retaining screw from bottom side of switch and housing assembly.
Pivot lower edge of housing out and up to remove housing assembly.
2. To remove switch, carefully pry apart switch retaining legs on connector and pry switch from connector with a small screwdriver.
3. To install, position switch to connector and press firmly into place.
4. Insert two housing spring legs into connector.
Pivot lower edge of housing down and install housing retaining screw.