Removal

REMOVAL

1. Raise hood and cover fenders. Disconnect battery ground cable.
2. Remove oil level indicator from left side of rear oil sump.
3. Remove air cleaner tube.
4. Remove fan shroud retaining bolts and position shroud over the fan.
5. Raise vehicle on hoist.
6. Drain crankcase and transmission.
7. Remove driveshaft assembly.
8. Disconnect speedometer cable from transmission.
9. Remove gearshift bellcrank lever from transmission.
10. Remove flywheel housing cover retaining bolts and remove cover.
11. Remove flywheel4o-converter attaching bolts.
12. Remove transmission control shaft.
13. Remove gear selector valve rod.
14. Remove starter motor retaining bolts and electrical connections and remove starter motor from vehicle.
15. Remove exhaust catalyst converter and muffler inlet pipes.
16. Support transmission with suitable transmission jack and remove converter housing to cylinder block attaching bolts.
17. Remove engine mount-to-No. 2 crossmember attaching bolts or nuts.
18. Remove No.3 crossmember and rear insulator support assemblies.
19. Remove neutral start switch electrical connection at transmission and disconnect transmission oil cooler lines.
20. Remove transmission and converter as an assembly.
21. Remove flywheel attaching bolts.
22. Remove engine rear cover plate.
23. Remove steering gear attaching bolts and position steering gear forward out of the way.
24. Raise and support engine in a position that allows for clearance for oil pan removal.
25. Remove oil pan attaching bolts and lower oil pan to No.2 crossmember.
26. Remove oil pump and pickup tube attaching bolts. Allow oil pump and pickup tube assembly to drop into oil pan.
27. Remove oil pan from vehicle.