Air Cleaner - Abrasion From Hood Insulator Pad
Article No. 85-16-14INSULATOR - HOOD - AIR CLEANER COVER ABRASION 5.0L UNITS BUILT PRIOR TO 5/1/85
FORD 1985 MUSTANG
Figure 11 - Air Cleaner Cover Correction:
Vehicles exhibiting air cleaner cover abrasion, caused by insufficient clearance between the hood sound insulator and air cleaner covers may be corrected by adding additional retainers to the insulator pad. See Figure 11.
1. Obtain two (2) 352976-S32 clips and one (1) N803387-S push pin.
2. Dimension two slots as shown in Figure 11.
3. Cut two slots (.750" x 1.50") in the hood insulator as shown.
4. Install two clips as shown.
5. Remove one (1) push pin at center of the hood insulator as shown.
6. Clear or remove burred inside the push pin hole.
7. Cut off the tip of the new push pin (N803387-S) - two (2) threads down from the tip.
8. Install the new push pin to replace the old push pin as shown.
PART NUMBER PART NAME CLASS
352976-S32 Clip (.64" ID and .91" SG
length) two (2) per vehicle
(5 per pkg.)
N803387-S Push Pin - one (1) per BS
vehicle (25 per pkg.)
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP16738A85
TIME: 0.3 Hr. DLR. CODING: Basic Part No. 9600 - Code: 59
Figure 11 - Air Cleaner Cover Correction:
1.OBTAIN TWO (2) 352976-S32 CLIPS AND (1) N803387-S PUSH PIN. 2.DIMENSION TWO SLOTS AS SHOWN, 3.CUT TWO SLOTS (.750" x 1.50") IN HOOD INSULATOR AS SHOWN.
4.INSTALL TWO CLIPS AS SHOWN. 5.REMOVE ONE (1) PUSH PIN AT CENTER OF HOOD INSULATOR AS SHOWN.
6.CLEAR OR REMOVE BURRED INSIDE THE PUSH PIN HOLE.
7.CUT OFF THE TIP OF THE NEW PUSH PIN (N803387-S) - TWO (2) THREADS DOWN FROM THE TIP. 8.INSTALL NEW PUSH PIN TO REPLACE OLD PUSH PIN AS SHOWN.