Printed-Heater Line Repair

REQUIRED MATERIAL

Printed-Heater Line Repair:

^ Thinner
^ Lead-tree gasoline
^ Tape
^ Fine brush
^ Conductive paint
1. Clean disconnected area with lead-free gasoline. Tape along both sides of heater element.
2. Mix conductive paint thoroughly. Thin the required amount of paint in a separate container with a small amount of thinner and paint break three times at 15 minutes intervals.
3. Remove tape and leave for a while before use (circuit complete).
4. Finish exterior with a knife after 24 hours (completely dry).

CAUTION: Clean glass with a soft cloth (dry or damp) along defogger heater element.