2. Evap. Emiss. Cntrl Sys. Leak Monitor (P0442, PO45O, P0455)
TEST REQUIREMENTS PROCEDUREAll of the following requirements should be met when carrying out a drive test.
1. Engine coolant temperature: 45° C (113° F) or less (before starting drive test, engine stopped)
2. Atmospheric temperature: 5° C (41° F) or more, 45° C (113° F) or less
3. Condition of A/T:
- Selector lever position: D range
- Overdrive switch: ON
4. One trip monitor will be completed by driving according to the steps below (from start to switch off). (it takes approx. 8 minutes)
a. Check that both engine coolant temperature and air intake temperature satisfy requirement 1 (engine stopped).
b. Monitor preparation period; Start the engine, and accelerate to 89 - 97 km/h (55 - 60 mph). For this period, acceleration, deceleration, or braking may be carried out. Continue driving between 89, and 97 km/h (55 and 60 mph) for 200 seconds or more. For this period, braking or throttle operation may be carried out if vehicle speed is within the specified value.
c. Drive between 89 and 97 km/h (55 and 60 mph) at a constant throttle angle (by not moving the throttle pedal as much as possible) for 150 seconds or more during monitor. Moreover, do not turn the steering wheel suddenly.
d. Decelerate and stop the vehicle. After stop, turn off the ignition switch.
Drive cycle pattern
CAUTION: Drive within the shaded area in the graph above.