Installation Service Points

SRS DIAGNOSIS UNIT INSTALLATION

Caution: The SRS may not activate if SDU is not installed properly, which could result in the SRS system not operating properly in a collision.





SRS DIAGNOSIS UNIT CONNECTOR CONNECTION

After connecting each harness connector securely and correctly to the SRS diagnosis unit, be sure to press down the lock lever of the SRS diagnosis unit.





POST INSTALLATION INSPECTION

Reconnect the negative battery terminal. Turn the ignition switch to "ON". Check if the SRS warning light illuminates for about 7 seconds and then stays off.

If yes, SRS system is functioning properly. If no, see diagnostic flow chart....Flow of Diagnosis